Resin Chair

Resin Chair

1 Comment

Transform an old plastic chair with unexpected color for a unique twist on a basic outdoor accessory.

Painted Patio Chairs

Materials:

  • Krylon Fusion for Plastic® - Twilight (#2440)
  • Resin Chair
  • Ammonia-based cleaner or paint thinner
  • Drop cloth
  • Low-tack masking tape
  • Drop cloth

Instructions:

  1. Using ammonia-based cleaner, wipe down chair to remove any dust or particles. If the plastic is new, wipe down with paint thinner for best results.
     
  2. Completely tape off any area that you do not wanted painted. A low tack tape is preferred.
     
  3. Shake Fusion can for 2 minutes or more.
     
  4. Applying in a well ventilated area, hold can 8 to 10 inches from surface and spray in a sweeping motion from side to side.
     
  5. EZ Touch Fan Spray tip can be adjusted to spray vertically or horizontally- see back label instructions.
     
  6. Apply a thin coat and allow to dry for 30 seconds.
     
  7. Apply multiple thin coats until surface is completely covered.
     
  8. Remove tape immediately after spraying.
     
  9. Fusion dries in 15 minutes or less, and can be handled in about 1 hour.
     
  10. Fusion must cure a full 7 days to become fully chip and scratch resistant.
     

For more project ideas, please visit www.krylon.com/projects.

Your Recently Viewed Projects

Leave a Comment

Rate

Cancel Reply to Comment

Thanks for your comment. Don't forget to share!

I love it.I was going to get rid of my old white set.Now I can't wait for the snow to go so I can get started.

Close

Report Inappropriate Comment

Are you sure you would like to report this comment? It will be flagged for our moderators to take action.

Thank you for taking the time to improve the content on our site.

Join our community of 5 million crafters!

Thank You for Signing Up!
There was an issue signing you up. Please check your email address, and try again.

More from "Outdoor"

 

 

Close Window