Colorful Tissue Wreaths

Colorful Tissue Wreaths

This colorful tissue wreath can be used year-round, but would look great around the holiday season. Tissue paper and ribbon are what brings this whole craft together into one lovely piece. Kathleen George shows us how to make it in six easy steps.

Find this and other Rainbow Crafts at "14 Simple DIY Rainbow Crafts for Springtime"!

Materials:

  • STYROFOAM™ Brand Foam:
    • Wreaths: 9" x 1-1/4" x 3/4"; two 6" x 1-1/4" x 5/8"
  • Coordinating grosgrain ribbon, 1" x 1/2 yd.
  • Brightly colored tissue paper, several large sheets in assorted colors
  • Scissors
  • Pencil
  • Ruler
  • Optional: Rotary cutter, cutting mat and metal ruler
  • Optional: Straight pins
  • Thick, white craft glue

 

Instructions:

Note: You will need a total of eighty 4" x 6" pieces of tissue paper to cover all three foam wreaths. To save time, stack several layers of tissue paper and use rotary cutter to cut multiple 4"-wide strips. Combine strips into stacks and cut multiple 6" lengths at a time.

  1. Set aside 40 tissue pieces for 9" foam wreath and 20 pieces for each 6" wreath.
     
  2. Fold each tissue piece in half lengthwise to measure 2" x 6". Cut 1-1/2"-long fringe along folded edge, every 1/4". Leave strips folded.
     
  3. Wrap and glue top edge of first fringed strip, opposite fold, around one side of wreath. Glue and pin ends at back to secure, leaving fringe loose.
     
  4. Wrap and glue second fringed strip around wreath, 1/2" below first and under fringe; pin ends if desired. Wrap and glue remaining tissue strips around wreath in same way until surface is completely covered. Repeat to cover all three wreaths.
     
  5. Use scissors to make small holes in center top and bottom of 9" wreath (A) and one 6" wreath (B); make small hole in center top of remaining 6" wreath (C). Using photo as guide, position wreaths on work surface with B in the center.
     
  6. Cut one 8" and two 4" ribbon lengths. Glue ends of 4" lengths into holes in wreaths, joining A and B and B and C together. Glue ends of 8" length into hole at top of A for hanger; pin to secure.

 

®™ Trademark of The Dow Chemical Company ("Dow") or an affiliated company of Dow. For more project ideas, please see styrofoamstyle.com.

 

 

Your Recently Viewed Projects

Leave a Comment

Rate

Cancel Reply to Comment

Thanks for your comment. Don't forget to share!

Close

Report Inappropriate Comment

Are you sure you would like to report this comment? It will be flagged for our moderators to take action.

Thank you for taking the time to improve the content on our site.

Join our community of 5 million crafters!

Thank You for Signing Up!
There was an issue signing you up. Please check your email address, and try again.

More from "Paper Crafts"

 

 

Close Window
Close Window
Get Our FREE Newsletter and Occasional Special Offers

Privacy Policy