Make it in Metal

search

Make it in Metal

By Linda Peterson for AMACO

Create the "Make it in Metal" jewelry with pendant.

Materials:

  • Amaco® ArtEmboss®— Medium Pewter, Bright Gold
  • Double-sided tape
  • FiberMark: White Board
  • Jewelry findings of choice

Steps:

  1. Cut out pattern from white board. Place pattern onto Pewter ArtEmboss® and cut out, leaving 1/4" border around all sides. Fold metal around to back. Apply double-stick tape to back. Cut out additional Pewter ArtEmboss® from pattern and apply to back.
     
  2. Run wooden stylus around metal to make them lay flat. Use wooden stylus to make tiny indentations around border.
     
  3. Crumple up a piece of ArtEmboss® Bright Gold. Open and flatten out as smooth as possible allowing small creases to remain. Cut into asymetrical shape. Apply double-stick tape to back and press onto front of pendant where desired.
     
  4. From a scrap piece of pewter, draw a spiral with the stylus then cut out. Apply double-stick tape to back and apply to front center of pendant.
     
  5. Punch with 1/16" paper punch. Add jump rings and other jewelry findings to complete pendant and earings.

Your Recently Viewed Projects

Leave a Comment

Rate

Cancel Reply to Comment

Thanks for your comment. Don't forget to share!

Close

Report Inappropriate Comment

Are you sure you would like to report this comment? It will be flagged for our moderators to take action.

Thank you for taking the time to improve the content on our site.

Close Window