Blue Bling Water Bottle Earrings

Get inspired by everyday objects. Blue Bling Water Bottle Earrings from Candace Jedrowicz can be created by combining a plastic blue drink bottle and copper enamel ink. Everyone will be shocked when they find out these earrings are repurposed from a water bottle!

Materials:

Blue water bottle
Craft knife
Scissors
Rubber stamp
Copper pigment ink
Needle tool
Wire cutters
Chain nose pliers
Round nose pliers
1/8″ Hole punch
20 Gauge wire

Instructions:

Keep both circles and squares with the curved side down during the whole process. Cut two 1″ circles and two 1″ squares from the bottle. Punch 1 hole at the top of the circles and 3 holes at the bottom.
Cut each square into 3 odd shapes for the dangles.
Punch a hole in the top of each dangle.
Ink the stamp with the pigment ink and press both circles on to the stamp. Lay the dangles together to stamp.
Holding each piece with a needle tool, heat with the heat tool held about 5″ from the table. Keep the heat on until the piece curls up a bit.
Use the needle tool to gently press the piece while heating with the heat gun, until it is only slightly curved. If the ink rubs off, it needs more heat. Keep the heat at a 5″ distance until the ink looks super shiny.
Use 6 jump rings to attach the dangles to the circles.
Use 2 pliers to hold each jump ring. Bend the ends of the ring to the side, slide a dangle and one hole of the circle onto the ring and close tightly.
Cut a 2 1/2″ wire for each ear wire. Using the round nose pliers make a ring on one end.
Bend the wire perpendicular to the ring.
Slide the circle onto the ring and close. Slide a tiny bit of coiled wire on the wire and make a sharp bend above the coil so it won’t slide off.
Bend the remainder of the wire over the handle of a pair of pliers. Gently sand the sharp edges of the wire ends.