Welcome guests into your home with this beautiful decorative wreath of STYROFOAM™ Brand Foam.
By Diane Flowers for STYROFOAM™ Brand Foam.
Materials:
STYROFOAM™ Brand Foam:
Wreath, 12" x 2-1/4" x 2"
Dried naturals, three each: mushrooms w/stems; natural okra; artichokes w/stems
Pheasant feathers: 16" long, six; 6" long, 10
Green reindeer moss, one bag
Porcupine grass, 10 stems
Fine-gauge floral wire
Floral pins, two
Ruler
Wire cutters or floral shears
Low-temp glue gun and glue sticks
Thick, white craft glue
Steps:
1. Use glue gun or craft glue to cover entire foam wreath with reindeer moss. Let dry.
2. Use wire cutters or floral shears to trim artichoke stems to 2" long. Glue and insert artichokes into bottom of wreath, forming semi-circle.
3. Glue and insert largest mushroom into outside bottom edge of wreath, below center artichoke, as shown. Glue and insert smallest mushroom into wreath in front of largest mushroom. Glue and insert remaining mushroom into inside bottom edge of wreath, behind center artichoke.
4. Glue and insert okra into inside bottom edge of wreath, behind mushroom. Trim okra as needed so tips do not extend above top of wreath.
5. Glue and insert five porcupine grass stems behind each side artichoke, trimming length as needed.
6. Glue and insert long feathers into outside bottom edge of wreath, centered behind largest mushroom.
7. Glue and insert six short feathers into wreath between artichokes and medium-sized mushroom. Glue and insert remaining short feathers into wreath below artichokes as shown.
8. For hanger, cut 10" length from wire. Fold wire in half and twist ends together to secure. Insert wire ends into top back of wreath. Secure each wire end with floral pin. Glue small pieces of reindeer moss to any exposed pins or stems. Let cone dry completely before hanging.
®™ Trademark of The Dow Chemical Company ("Dow") or an affiliated company of Dow. For more project ideas, please see styrofoamstyle.com.
